What are carpet rods used for?

In the old days, carpet rods actually held the carpet runners in place on stairs. These fasteners would allow the home owner to periodically move the runner to evenly distribute wear over fine carpeting. Carpet rods also allowed removal of the runners for cleaning in the days before vacuum cleaners. The home owner could simply bring the carpet outdoors and shake off dirt.
Today our carpet runners are installed by tacking them to the staircase. This way, the carpet runner cannot shift out from under our feet, which would be dangerous.
The carpet rods and bracket sets, today, serve a decorative function, adding warmth and richness to your home. By highlighting your staircase and your fine carpeting, the carpet rods provide the finishing touch to a well-dressed home.

Back To Top

How long should my carpet rods be?

Traditionally, the carpet rod brackets lined-up with the sides of the runner. To install the carpet rods using this method, simply measure the carpet width, then add 1 ½ inches to determine the correct rod width. Keep in mind, however, that the rod can extend over the runner by up to 2 inches on the sides and still look good. The choice is up to you!

Back To Top

How do I cut carpet rods?

To cut the rods, use a hack saw or pipe cutter to make a clean cut. Don't worry about the cut end looking jagged; file it lightly, the rest will be hidden by the carpet bracket and will not show. Always remember to wear safety glasses when working with any metal cutting tools.
Remember: Carpet rods cannot be returned once they have been cut. If your unsure about what your doing contact a professional carpet installer or carpenter. Full directions will accompany your order.

Back To Top

Do I need a carpet rod on the floor where the stair case ends?

Most people use a carpet rod under the bottom stair. The sets of carpet rods and brackets are commonly sold in 13 sets.

Back To Top

Do I need a professional to install my carpet rods?

The handy homeowner can easily install the carpet rods his or herself. Plot where to drill the holes for the screws in the brackets by marking the holes on the stairs with a pencil. Screw in the brackets, lift the bracket arms, and place the rod in the end brackets.

Back To Top

How do I clean my carpet rods?

All of our carpet rod sets are lacquered. There is no cleaning involved other than to use a soft, dry cloth to dust them occassionally.